D-Link DES-3350SR Reference Manual page 424

Entering the Type combination
type_2 is functionally equivalent to external. Entering the combination internal external is functionally equivalent to all.
Entering the metric 0 specifies transparency.
Example Usage:
To add route redistribution settings:
local>create route redistribute dst rip src ospf all metric 2
Command: create route redistribute dst rip src ospf all metric 2
Success.
local>
config route redistribute dst ospf src
Purpose
Syntax
Description
DES-3350SR Layer 3 Gigabit Switch
Route Source Metric
OSPF 0 to 16
Static 0 to 16
internal type_1 type_2 is functionally equivalent to all. Entering the combination type_1
Used configure route redistribution settings for the exchange of RIP
routes to OSPF routes on the switch.
config route redistribute dst ospf src [static | rip | local]
{mettype [1 | 2] | metric <value>}
Route redistribution allows routers on the network
different routing protocols to exchange routing information. This is
accomplished by comparing the routes stored in the various router's
routing tables and assigning appropriate metrics. This information is
then exchanged among the various routers according to the
individual routers current routing protocol. The switch can
redistribute routing information between the OSPF and RIP routing
protocols to all routers on the network that are running OSPF or
RIP. Routing information entered into the Static Routing Table on
the local switch is also redistributed.
Type
all
type_1
type_2
inter+e1
inter+e2
external
internal
not applicable
176
that are running