Dvmrp Commands - D-Link DES-3350SR Reference Manual

The DVMRP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
config dvmrp
enable dvmrp
disable dvmrp
show dvmrp neighbor
show dvmrp nexthop
show dvmrp
routing_table
show dvmrp
Each command is listed, in detail, in the following sections.
config dvmrp
Purpose
Syntax
Description
DES-3350SR Layer 3 Gigabit Switch
Parameters
[ipif <ipif_name 12> | all] {metric <value 1-31> | probe <sec 1-
65535> | neighbor_timeout <sec 1-65535> | state [enable |
disable]}
{ipif <ipif_name 12> | ipaddress <network_address>}
{ipaddress <network_address> | ipif <ipif_name 12>}
{ipaddress <network_address>}
{ipif <ipif_name 12>}
Used to configure DVMRP on the switch.
config dvmrp [ipif <ipif_name 12> | all] {metric <value 1-31> |
probe <sec 1-65535> | neighbor_timeout <sec 1-65535> |
state [enable | disable]}
This command is used to configure DVMRP on the switch.
194
DVMRP C
OMMANDS
32