Link Aggregation Commands - D-Link DES-3350SR Reference Manual

The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create
link_aggregation
delete
link_aggregation
config
link_aggregation
config
link_aggregation
algorithm
show link_aggregation
config lacp_port
show lacp_port
Each command is listed, in detail, in the following sections.
create link_aggregation
Purpose
Syntax
Description
DES-3350SR Layer 3 Gigabit Switch
Parameters
group_id <value 1-6> {type [lacp | static]}
group_id <value 1-6>
group_id <value 1-6> {master_port <port> | ports <portlist> state
[enable | disable]}
[mac_source | mac_destination | mac_source_dest | ip_source |
ip_destination | ip_source_dest]
{group_id <value 1-6> | algorithm}
<portlist> mode [active | passive]
{<portlist>}
NOTE: As a stand-alone switch or as a master switch in a switch stack,
the switch number will be referred to as 15 for all configurations, graphs
and tables.
Used to create a link aggregation group on the switch.
create link_aggregation group_id <value 1-6> {type [lacp |
static]}
This command will create a link aggregation group with a unique
identifier.
L A
INK GGREGATION
103
16
C
OMMANDS