Igmp Commands - D-Link DES-3350SR Reference Manual

The IGMP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
config igmp
show igmp
show igmp group
Each command is listed, in detail, in the following sections.
config igmp
Purpose
Syntax
Description
Parameters
Restrictions
DES-3350SR Layer 3 Gigabit Switch
Parameters
[ipif <ipif_name 12> | all] {version <value 1-2> | query_interval
<sec 1-65535> max_response_time <sec 1-25> |
robustness_variable <value 1-255> |
last_member_query_interval <sec 1-25> | state [enable | disable]
{ipif <ipif_name 12>}
{group <group>} {ipif <ipif_name 12>}
Used to configure IGMP on the switch.
config igmp [ipif <ipif_name 12> | all] {version <value 1-2> |
{query_interval <sec 1-25> | max_response_time <sec 1-25> |
robustness_variable <value 1-255> |
last_member_query_interval <sec 1-25> | state [enable |
disable]
This command allows you to configure IGMP snooping on the
switch.
<ipif_name 12> The name of the IP interface for which you want
to configure IGMP.
all Specifies all the IP interfaces on the switch.
version <value 1-2> The IGMP version number.
query_interval <sec 1-25>
general query transmissions, in seconds.
max_response_time <sec 1-25>
seconds that the switch will wait for reports from members.
robustness_variable <value 1-255>
permitted packet loss that guarantees IGMP.
last_member_query_interval <value 1-25>
Time inserted into Group-Specific Queries sent in response to
Leave Group messages, and is also the amount of time between
Group-Specific Query messages. The default is 1 second
state [enable | disable]
specified IP interface.
Only administrator-level users can issue this command.
120
IGMP C
The time in seconds between
Enter the maximum time in
This value states the
The Max Response
Enables or disables IGMP for the
19
OMMANDS