D-Link DES-3350SR Reference Manual page 235

local>create ospf virtual_link 10.1.12 20.1.1.1 hello_interval 10
Command: create ospf virtual_link 10.1.12 20.1.1.1 hello_interval 10
Success.
local>
config ospf virtual_link
Purpose
Syntax
Description
Parameters
DES-3350SR Layer 3 Gigabit Switch
Used to configure the OSPF virtual interface settings.
config ospf virtual_link <area_id> <neighbor_id>
{hello_interval <sec 1-65535> | dead_interval <sec 1-65535> |
authentication [none | simple <password 8> | md5 <key_id 1-
255>]}
This command is used to configure the OSPF virtual interface
settings.
<area_id> A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<neighbor_id> The OSPF router ID for the remote area. This is
a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx)
that uniquely identifies the remote area's Area Border Router.
hello_interval <sec 1-65535>
interval between the transmission of OSPF Hello packets, in
seconds. Between 1 and 65535 seconds can be specified. The
Hello Interval, Dead Interval, Authorization Type, and
Authorization Key should be the same for all routers on the same
network.
dead_interval <sec 1-65535>
length of time between the receipt of Hello packets from a
neighbor router before the selected area declares that router
down. An interval between 1 and 65535 seconds can be
specified. The Dead Interval must be evenly divisible by the Hello
Interval.
authentication – Enter the type of authentication preferred. The
user may choose between:
§ none –
Choosing this parameter will require no
authentication.
§ simple <password 8>
a simple authentication which includes a case-sensitive
password of no more than 8 characters.
§ md5 <key_id 1-255>
authentication based on md5 encryption
configured MD5 key ID (1 to 255) is required.
231
Allows the specification of the
Allows the specification of the
Choosing this parameter will set
Choosing this parameter will set
A previously