Time And Sntp Commands - D-Link DES-3350SR Reference Manual

The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NPT)) commands in the Command
Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
config sntp
show sntp
enable sntp
disable sntp
config time
show time
Each command is listed, in detail, in the following sections.
config sntp
Purpose
Syntax
Description
Parameters
Restrictions
DES-3350SR Layer 3 Gigabit Switch
Parameters
{primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
{time <time hh:mm:ss> | date <date ddmmyyyy> | time-zone {operator
[+ |-] | hour <gmt_hour 0-13> | min <minute 0-59>} | dst [disable |
repeating {s-which <start_which 1-4,last> | s-day <start_day sun-sat> |
s-mth <start_mth 1-12> | s-time <start_time hh:mm> | e-
which<end_which 1-4,last> | e-day <end_day sun-sat> | e-
mth<end_mth 1-12> | e-time <end_time hh:mm> | offset [30 | 60]} |
annual {s-date <start_date 1-31> | s-mth <start_mth 1-12> | s-time
<start_time hh:mm> | e-date <end_date 1-31> | e-mth <end_mth 1-
12> | e-time <end_time hh:mm> | offset [30 | 60]}]}
Used to setup SNTP service.
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-
interval <int 30-99999>}
Use this command to configure SNTP service from an SNTP
server. SNTP must be enabled for this command to function (See
enable sntp).
primary This is the primary server the SNTP information will be
taken from.
§ <ipaddr>
The IP address of the primary server.
secondary This is the secondary server the SNTP information
will be taken from in the event the primary server is unavailable.
§ <ipaddr>
The IP address for the secondary server.
poll-interval <int 30-99999>
for updated SNTP information. The polling interval ranges from 30
to 99,999 seconds.
Only administrator-level users can issue this command. SNTP
service must be enabled for this command to function (enable
sntp).
160
T SNTP C
IME AND
This is the interval between requests
25
OMMANDS