D-Link DES-3350SR Reference Manual page 279

Command
create snmp group
delete snmp group
show snmp groups
create snmp host
delete snmp host
show snmp host
create trusted_host
delete trusted_host
show trusted_host
enable snmp traps
enable snmp
authenticate traps
disable snmp traps
disable snmp
authenticate traps
config snmp system_
contact
config snmp system_
location
config snmp system
_name
enable rmon
disable rmon
Each command is listed, in detail, in the following sections.
create snmp user
Purpose
Syntax
DES-3350SR Layer 3 Gigabit Switch
Parameters
<groupname 32> {v1 | v2c |v3 [noauth_nopriv | auth_nopriv |
auth_priv ]} {read_view <view_name 32> | write_view <view_name
32> | notify_view <view_name 32>}
<groupname 32>
<ipaddr> {v1 |v2c | v3 [noauth_nopriv | auth_nopriv | auth_priv]}
<auth_string 32>
<ipaddr>
{<ipaddr>}
<ipaddr>
<ipaddr>
{<ipaddr>}
<sw_contact>
<sw_location>
<sw_name>
Used to create a new SNMP user and adds the user to an SNMP
group that is also created by this command.
create snmp user <username 32> <groupname 32> {encrypted
[by_password auth [md5 <auth_password 8-16> | sha
<auth_password 8-20>] priv [none | des <priv_password 8-
16> ] | by_key auth [md5 <auth_key 32-32>| sha <auth_key 40-
40>] priv [none | des <priv_key 32-32> ]]}
31