D-Link DES-3350SR Reference Manual page 149

config radius add
Description
Parameters
Restrictions
Example usage:
To configure the RADIUS server communication settings:
local>config radius add 1 10.48.74.121 key dlink default
Command: config radius add 1 10.48.74.121 key dlink default
Success.
local>
config radius delete
Purpose
Syntax
Description
Parameters
DES-3350SR Layer 3 Gigabit Switch
The config radius add command is used to add RADIUS
servers to the switch.
<server_index 1-3> Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server
settings can be entered on the switch. The lowest index number
will have a higher authenticative priority
<server_ip> The IP address of the RADIUS server.
key Specifies that a password and encryption key will be used
between the switch and the RADIUS server.
§ <passwd 32>
RADIUS server and the switch. Up to 32 characters can be
used.
Uses the default udp port number in both the "auth_port"
default
and "acct_port" settings.
auth_port <udp_port_number>
authentication requests. The default is 1812.
acct_port <udp_port_number>
accounting requests. The default is 1813.
Only administrator-level users can issue this command.
Used to delete a previously entered RADIUS server configuration.
config radius delete <server_index 1-3>
The config radius delete command is used to delete a previously
entered RADIUS server configuration.
<server_index 1-3> A number identifying the current set of
RADIUS server settings the user wishes to delete. Up to 3 groups
of RADIUS server settings can be entered on the switch.
145
The shared-secret key used by the
The UDP port number for
The UDP port number for