Basic Ip Commands - D-Link DES-3350SR Reference Manual

The IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
enable ipif
create ipif
config ipif
show ipif
delete ipif
disable ipif
Each command is listed, in detail, in the following sections.
enable ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the ipif function on the switch:
create ipif
DES-3350SR Layer 3 Gigabit Switch
Parameters
{<ipif_name 12> | all}
<ipif_name12> <network_address> <vlan_name 32> {secondary |
state [enable | disable]}
<ipif_name12> [{ipaddress <network_address> | {vlan
<vlan_name 32> | state [enable | disable]} | bootp | dhcp]
<ipif_name 12>
<ipif_name 12> | all
<ipif_name 12> | all
Used to enable an IP interface on the switch.
enable ipif {<ipif_name 12> | all}
This command will enable the IP interface function on the switch.
<ipif_name 12>
name cannot exceed 12 characters.
all – Entering this parameter will delete all the IP interfaces
currently configured on the switch.
none
local>enable ipif s2
Command: enable ipif s2
Success.
local>
B
ASIC
The name for the IP interface to be created. This
115
18
IP C
OMMANDS