D-Link DES-3350SR Reference Manual page 143

show 802.1x auth_state
Parameters
Restrictions
Example usage:
To display the 802.1x auth state for ports 1-4:
local> show 802.1x auth_state ports 1-4
Command: show 802.1x auth_state ports 1-4
Port Auth PAE State Backend State Port Status
---- -------------- ------------- ------------
1
2
3
4
CTRL+C ESC q
config 802.1x auth_mode
Purpose
Syntax
Description
DES-3350SR Layer 3 Gigabit Switch
ports <portlist>
The following details what is displayed:
Port number
Auth PAE State: Initialize / Disconnected / Connecting /
Authenticating / Authenticated / Held / ForceAuth / ForceUnauth
Shows the current state of the Authenticator PAE.
Backend State: Request / Response / Fail / Idle / Initialize /
Success / Timeout
Authenticator.
Port Status: Authorized / Unauthorized
authentication process. Authorized means that the user was
authenticated, and can access the network. Unauthorized
means that the user was not authenticated, and cannot access
the network.
Only administrator-level users can issue this command.
ForceAuth Success
ForceAuth Success
ForceAuth Success
ForceAuth Success
Quit SPACE n
Used to configure the 802.1x authentication mode on the switch.
config 802.1x auth_mode [port_based | mac_based]
The config 802.1x auth_mode command is used to enable either
the port-based or MAC-based 802.1x authentication feature on the
switch.
Specifies a port or range of ports.
Shows the physical port number on the switch.
Shows the current state of the Backend
Authorized
Authorized
Authorized
Authorized
Next Page Enter Next Entry
139
Shows the result of the
a All