Port Mirroring Commands - D-Link DES-3350SR Reference Manual

The port mirroring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config mirror port
enable mirror
disable mirror
show mirror
Each command is listed, in detail, in the following sections.
config mirror port
Purpose
Syntax
Description
Parameters
DES-3350SR Layer 3 Gigabit Switch
Parameters
<port> [add | delete] source ports <portlist> [rx | tx | both]
NOTE: As a stand-alone switch or as a master switch in a switch stack,
the switch number will be referred to as 15 for all configurations, graphs
and tables.
Used to configure a mirror port
config mirror port <port> add source ports <portlist> [rx | tx |
both]
This command allows a range of ports to have all of their traffic
also sent to a designated port, where a network sniffer or other
device can monitor the network traffic. In addition, you can specify
that only traffic received by or sent by one or both is mirrored to
the Target port.
port <port> This specifies the Target port (the port where
mirrored packets will be sent).
add source ports – The port or ports being mirrored. This cannot
include the Target port.
§ <portlist>
mirrored. That is, the range of ports in which all traffic will be
copied and sent to the Target port.
§ rx
Allows the mirroring of only packets received by
(flowing into) the port or ports in the port list.
tx Allows the mirroring of only packets sent to (flowing out of) the
port or ports in the port list.
both Mirrors all the packets received or sent by the port or ports
in the port list.
P M
ORT IRRORING
source port pair on the switch.
This specifies a range of ports that will be
92
14
C
OMMANDS