The RIP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
config rip
enable rip
disable rip
show rip
Each command is listed, in detail, in the following sections.
config rip
Purpose
Syntax
Description
DES-3350SR Layer 3 Gigabit Switch
Parameters
[ipif <ipif_name 12> | all] {authentication [enable <password
16> | disable] | tx_mode [disable | v1_only | v1_compatible |
v2_only] | rx_mode [v1_only | v2_only | v1_or_v2 | disable] state
[enable | disable]}
ipif <ipif_name 12>
Used to configure RIP on the switch.
config rip [ipif <ipif_name 12> | all] {authentication [enable
<password 16> | disable] | tx_mode [disable | v1_only |
v1_compatible | v2_only] | rx_mode [v1_only | v2_only |
v1_or_v2 | disable] state [enable | disable]}
This command is used to configure RIP on the switch.
190
31
RIP C
OMMANDS