D-Link DES-3350SR Reference Manual page 390

config 802.1x auth_parameter
Parameters
Restrictions
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20 of switch 1:
DES-3350SR Layer 3 Gigabit Switch
<portlist> Specifies a port or range of ports.
all Specifies all of the ports on the switch.
default Returns all of the ports in the specified range to their
802.1x default settings.
direction [both | in] Determines whether a controlled port blocks
communication in both the receiving and transmitting directions, or
just the receiving direction.
port_control Configures the administrative control over the
authentication process for the range of ports. The user has the
following authentication options:
force_auth Forces the Authenticator for the port to
become authorized. Network access is allowed.
auto Allows the port's status to reflect the outcome of
the authentication process.
force_unauth
become unauthorized. Network access will be blocked.
quiet_period <sec 0-65535>
between authentication failure and the start of a new
authentication attempt.
tx_period <sec 1-65535>
response from a supplicant (user) to send EAP Request/Identity
packets.
supp_timeout <sec 1-65535>
response from a supplicant (user) for all EAP packets, except for
the Request/Identity packets.
server_timeout <sec 1-65535>
wait for a response from a RADIUS server.
max_req <value 1-10>
sending packets to a supplicant (user).
reauth_period <sec 1-65535>
between successive re-authentications.
enable_reauth [enable | disable]
switch will re-authenticate. Enabled causes re-authentication of
users at the time interval specified in the Re-authentication Period
field, above.
Only administrator-level users can issue this command.
142
Forces the Authenticator for the port to
Configures the time interval
Configures the time to wait for a
Configures the time to wait for a
Configure the length of time to
Configures the number of times to retry
Configures the time interval
Determines whether or not the