Introduction; Accessing The Switch Via The Serial Port - D-Link DES-3350SR Reference Manual

The Switch can be managed through the switch's serial port, Telnet, or the Web-based management agent. The Command Line
Interface (CLI) can be used to configure and manage the switch via the serial port or Telnet interfaces.
This manual provides a reference for all of the commands contained in the CLI. Configuration and management of the switch via
the Web-based management agent is discussed in the User's Guide.

Accessing the Switch via the Serial Port

The switch's serial port's default settings are as follows:
9600 baud
no parity
8 data bits
1 stop bit
A computer running a terminal emulation program capable of emulating a VT-100 terminal and a serial port configured as above
is then connected to the switch's serial port via an RS-232 DB-9 cable.
With the serial port properly connected to a management computer, the following screen should be visible. If this screen does not
appear, try pressing Ctrl+r to refresh the console screen.
There is no initial username or password. Just press the Enter key twice to display the CLI input cursor
command line where all commands are input.
Setting the Switch's IP Address
DES-3350SR Layer 3 Gigabit Switch
Figure 1-1. Initial CLI screen
1
1
I
NTRODUCTION
local>. This is the