Dns Relay Commands - D-Link DES-3350SR Reference Manual

The DNS relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config dnsr
enable dnsr
disable dnsr
show dnsr
Each command is listed, in detail, in the following sections.
config dnsr
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To set IP address 10.43.21.12 of primary.
DES-3350SR Layer 3 Gigabit Switch
Parameters
{[primary | secondary] nameserver <ipaddr> | [add | delete] static
<domain_name 32> <ipaddr>}
{cache | static}
{cache | static}
{static}
Used to configure the DNS relay function.
config dnsr {[primary | secondary] nameserver <ipaddr> |
[add | delete] static <domain_name 32> <ipaddr>}
This command is used to configure the DNS relay function on
the switch.
primary Indicates that the IP address below is the address of
the primary DNS server.
secondary Indicates that the IP address below is the address
of the secondary DNS server.
nameserver <ipaddr>
[add | delete] – Indicates if the user wishes to add or delete the
DNS relay function.
<domain_name 32> The domain name of the entry.
<ipaddr> The IP address of the entry.
Only administrator-level users can issue this command.
185
DNS R
ELAY
The IP address of the DNS nameserver.
30
C
OMMANDS