Port Security Commands - D-Link DES-3350SR Reference Manual

The switch port security commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
config port_security ports
show port_security
Each command is listed, in detail, in the following sections.
config port_security ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the port security:
DES-3350SR Layer 3 Gigabit Switch
Parameters
[ <portlist>| all ] { admin_state [enabled | disabled]
|max_learning_addr <max_lock_no 0-10> |
lock_address_mode [DeleteOnTimeout|DeleteOnReset]}
{ports <portlist>}
NOTE: As a stand-alone switch or as a master switch in a switch stack,
the switch number will be referred to as 15 for all configurations, graphs
and tables.
Used to configure port security settings.
[ <portlist>| all ] { admin_state [enabled | disabled]
|max_learning_addr <max_lock_no 0-10> |
lock_address_mode [DeleteOnTimeout|DeleteOnReset]}
This command allows for the configuration of the port security
feature. Only the ports listed in the <portlist> are effected.
<portlist> Specifies a port or range of ports to be configured.
all Configure port security for all ports on the switch.
admin_state [enable | disable] – Enables or disables port security
for the listed ports.
max_learning_addr <max_lock_no 0-10> - Use this to limit the
number of MAC addresses dynamically listed in the FDB for the
ports.
lock_address_mode [DeleteOnTimeout | DeleteOnReset] – Delete
FDB dynamic entries for the ports on timeout of the FDB (see
Forwarding Database Commands). Specify DeleteOnReset to
delete all FDB entries, including static entries upon system reset or
rebooting.
Only administrator-level users can issue this command.
P S
ORT ECURITY
27
6
C
OMMANDS