D-Link DES-3350SR Reference Manual page 195

config rip
Parameters
Restrictions
Example Usage:
To change the RIP receive mode for the IP interface System:
DES-3350SR Layer 3 Gigabit Switch
<ipif_name 12> The name of the IP interface.
all – To configure all RIP receiving mode for all IP interfaces.
authentication [enable | disable]
authentication for RIP on the switch.
§ <password 16>
sensitive password.
tx_mode Determines how received RIP packets will be
interpreted – as RIP version V1 only, V2 Only, or V1
Compatible (V1 and V2). This entry specifies which version of
the RIP protocol will be used to transfer RIP packets. The
Disabled entry prevents the reception of RIP packets.
§ disable
Prevents the transmission of RIP packets.
§ v1_only
Specifies that only RIP v1 packets will be
transmitted.
§ v1_compatible – Specifies that only RIP v1 compatible
packets will be transmitted.
§ v2_only - Specifies that only RIP v2 packets will be
transmitted.
rx_mode Determines how received RIP packets will be
interpreted – as RIP version V1 only, V2 Only, or V1 or V2.
This entry specifies which version of the RIP protocol will be
used to receive RIP packets. The Disabled entry prevents the
reception of RIP packets.
§ v1_only
Specifies that only RIP v1 packets will be
transmitted.
§ v2_only - Specifies that only RIP v2 packets will be
transmitted.
§ v1_or_v2 - Specifies that only RIP v1 or v2 packets will
be transmitted.
state [enable | disable]
on the switch.
Only administrator-level users can issue this command.
191
Enables or disables
Allows the specification of a case-
Allows RIP to be enabled and disabled