D-Link DES-3350SR Reference Manual page 360

show address_binding
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show IP-MAC Binding on the switch:
DES-3350SR Layer 3 Gigabit Switch
local>config address_binding ip_mac ports 2 state enable
Command: config address_binding ip_mac ports 2 state
enable
Success.
local>
Used to display IP-MAC Binding entries.
[ip_mac {ipaddress <ipaddr> mac_address<macaddr>}|
blocked {vlan_name <vlan_name> mac_address <macaddr>}
|ports]
This command will display IP-MAC Binding entries. Three different
kinds of information can be viewed.
IP_MAC – Address Binding enties can be viewed by
entering the physical and IP addresses of the device.
Blocked – Blocked address binding entries (bindings
between VLAN names and MAC addresses) can be
viewed by entering the VLAN name and the physical
address of the device.
Ports - The number of enabled ports on a device.
<ipaddr> The IP address of the device where the IP-MAC binding
is made.
<macaddr> The MAC address of the device where the IP-MAC
binding is made.
<vlan_name> The VLAN name of the VLAN that is bound to a
MAC address in order to block a specific device on a known VLAN.
none
112