D-Link DES-3350SR Reference Manual page 352

create link_aggregation
Parameters
Restrictions
Example usage:
To create a link aggregation group:
local>create link_aggregation group_id 1
Command: create link_aggregation group_id 1
Success.
local>
delete link_aggregation group_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete link aggregation group:
DES-3350SR Layer 3 Gigabit Switch
<value 1-6> Specifies the group ID. The switch allows up to 6
link aggregation groups to be configured. The group number
identifies each of the groups.
type – Specify the type of link aggregation used for the group. If
the type is not specified the default type is static.
§ lacp – This designates the port group as LACP compliant.
LACP allows dynamic adjustment to the aggregated port
group. LACP compliant ports may be further configured (see
config lacp_ports). LACP compliant must be connected to
LACP compliant devices.
§ static – This designates the aggregated port group as
static. Static port groups can not be changed as easily as
LACP compliant port groups since both linked devices must
be manually configured if the configuration of the trunked
group is changed. If static link aggregation is used, be sure
that both ends of the connection are properly configured and
that all ports have the same speed/duplex settings.
Only administrator-level users can issue this command.
Used to delete a previously configured link aggregation group.
delete link_aggregation group_id <value 1-6>
This command is used to delete a previously configured link
aggregation group.
<value 1-6> Specifies the group ID. The switch allows up to 6 link
aggregation groups to be configured. The group number identifies
each of the groups.
Only administrator-level users can issue this command.
104