D-Link DES-3350SR Reference Manual page 224

create ospf aggregation
Parameters
Restrictions
Usage Example:
To create an OSPF area aggregation:
local>create ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type
summary advertise enable
Command: create ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary advertise enable
Success.
local>
delete ospf aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example
DES-3350SR Layer 3 Gigabit Switch
<area_id> A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<network_address> The 32-bit number in the form of an IP
address that uniquely identifies the network that corresponds to the
OSPF Area.
lsdb_type summary The type of address aggregation.
advertise [enable | disable]
be enabled or disabled.
Only administrator-level users can issue this command.
Used to delete an OSPF area aggregation configuration.
delete ospf aggregation <area_id> <network_address>
lsdb_type summary
This command is used to delete an OSPF area aggregation
configuration.
<area_id> A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<network_address> The 32-bit number in the form of an IP
address that uniquely identifies the network that corresponds to the
OSPF Area.
lsdb_type summary Specifies the type of address aggregation.
Only administrator-level users can issue this command.
220
Allows for the advertisement trigger to