D-Link DES-3350SR Reference Manual page 355

show link_aggregation
Description
Parameters
Restrictions
Example usage:
To display Link Aggregation configuration:
local>show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source-dest
Group ID
Master Port
Member Port
Active Port:
Status
Flooding Port
DES-3350SR:4
config lacp_ports
Purpose
Syntax
Description
DES-3350SR Layer 3 Gigabit Switch
This command will display the current link aggregation configuration
of the switch.
group_id <value 1-6> Specifies the group ID. The switch allows up
to 6 link aggregation groups to be configured. The group number
identifies each of the groups.
algorithm Allows you to specify the display of link aggregation by
the algorithm in use by that group.
None.
: 1
: 2:10
: 1:5-1:10,2:10
: Disabled
: 1:5
Used to configure settings for LACP compliant ports.
config lacp_ports <portlist> mode [active | passive]
This command is used to configure ports that have been
previously designated as LACP ports (see create
link_aggregation).
107