D-Link DES-3350SR Reference Manual page 68

config stp
Parameters
Restrictions
Example usage:
To configure STP with maxage 18 and hellotime 4:
local>config stp maxage 18 hellotime 4
Command: config stp maxage 18 hellotime 4
Success.
local>
config stp ports
DES-3350SR Layer 3 Gigabit Switch
maxage <value 6-40>
seconds) that the switch will wait to receive a BPDU packet before
reconfiguring STP. The user may choose a time between 6 and 40
seconds. The default is 20 seconds.
hellotime <value 1-10>
of configuration messages by the root device. The user may
choose a time between 1 and 10 seconds. The default is 2
seconds.
forwarddelay <value 4-30>
seconds) that the root device will wait before changing states. The
user may choose a time between 4 and 30 seconds. The default is
15 seconds.
priority <value 0-61440>
61440 that is used in determining the root device, root port, and
designated port. The device with the highest priority becomes the
root device. The lower the numerical value, the higher the priority.
The default is 32,768.
version [rstp | stp] - Select the Spanning Tree Protocol version
used for the switch.
stp – Select this parameter for IEEE 802.1d STP and for
IEEE 802.1w STP compatibility mode.
rstp - Select this parameter for IEEE 802.1w Rapid STP
mode.
fbpdu [enable | disable]
packets from other network devices when STP is disabled on the
switch. The default is enabled.
txholdcount <1-10> - The maximum number of Hello packets
transmitted per interval. Default value = 3.
Only administrator-level users can issue this command.
64
The maximum amount of time (in
The time interval between transmission
The maximum amount of time (in
A numerical value between 0 and
Allows the forwarding of STP BPDU