Ip-Mac Binding - D-Link DES-3350SR Reference Manual

The IP-MAC Binding commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create
address_binding
ip_mac ipaddress
config
address_binding
ip_mac ipaddress
config
address_binding
ip_mac ports
show address_binding
delete
address_binding
Each command is listed, in detail, in the following sections.
create address_binding ip_mac ipaddress
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create address binding on the switch:
DES-3350SR Layer 3 Gigabit Switch
Parameters
<ipaddr> mac_address <macaddr>
<ipaddr> mac_address <macaddr>
[<portlist> | all] state [enable | disable]
[ip_mac {ipaddress <ipaddr> mac_address <macaddr> }|blocked
{vlan_name <vlan_name> mac_address <macaddr>} |ports]
[ip_mac [ipaddress <ipaddr> {mac_address <macaddr>} |all]
|blocked [all| vlan_name <vlan_name> mac_address <macaddr>]]
Used to create an IP-MAC Binding entry.
<ipaddr> mac_address <macaddr>
This command will create an IP-MAC Binding entry.
<ipaddr> The IP address of the device where the IP-MAC binding
is made.
<macaddr> The MAC address of the device where the IP-MAC
binding is made.
Only administrator-level users can issue this command.
local>create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04
Command: create address_binding ip_mac ipaddress
10.1.1.3 mac_address 00-00-00-00-00-04
Success.
local>
110
17
IP-MAC B
INDING