D-Link DES-3350SR Reference Manual page 391

local>config 802.1x auth_parameter ports 1-4 direction both
Command: config 802.1x auth_parameter ports 1-4 direction both
Success.
local>
config 802.1x init
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To initialize the authentication state machine of some or all:
local> config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
local>
DES-3350SR Layer 3 Gigabit Switch
Used to initialize the 802.1x function on a range of ports.
config 802.1x init [port_based ports [<portlist | all>] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr}]
The config 802.1x init command is used to immediately initialize
the 802.1x functions on a specified range of ports or for specified
MAC addresses operating from a specified range of ports.
port_based – This instructs the switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization can
then be specified.
§ <portlist>
Specifies a port or range of ports.
§ all
Specifies all of the ports on the switch.
mac_based - This instructs the switch to initialize 802.1x functions
based on the MAC address of a device on a specific port or range
of ports. MAC address approved for initialization can then be
specified.
§ <portlist>
Specifies a port or range of ports.
§ all
Specifies all of the ports on the switch.
mac_address <macaddr> - Specifies the MAC address of the
client the user wishes to add.
Only administrator-level users can issue this command.
143