Network Monitoring Commands - D-Link DES-3350SR Reference Manual

The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
show packet ports
show error ports
show utilization
clear counters
clear log
show log
Each command is listed, in detail, in the following sections.
show packet ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the packets analysis for port 7 of module 2:
DES-3350SR Layer 3 Gigabit Switch
N
Parameters
<portlist>
<portlist>
{cpu}
ports <portlist>
index <value>
NOTE: As a stand-alone switch or as a master switch in a switch stack,
the switch number will be referred to as 15 for all configurations, graphs
and tables.
Used to display statistics about the packets sent and received by
the switch.
show packet ports <portlist>
This command is used to display statistics about packets sent and
received by ports specified in the port list.
<portlist> Specifies a port or range of ports to be displayed.
None.
M
ETWORK ONITORING
58
9
C
OMMANDS