Spanning Tree Commands - D-Link DES-3350SR Reference Manual

The switch supports 802.1d STP and 802.1w Rapid STP. The spanning tree commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command
config stp
config stp ports
enable stp
disable stp
show stp
show stp ports
Each command is listed, in detail, in the following sections.
config stp
Purpose
Syntax
Description
DES-3350SR Layer 3 Gigabit Switch
Parameters
{maxage <value 6-40> | hellotime <value 1-10> | forwarddelay
<value 4-30> | priority <value 0-61440> | version [rstp | stp] |
txholdcount <value 1-10> | fbpdu [enable | disable]}
<portlist> {cost [auto | <value 1-200000000>] | priority <value 0-
240> | migrate [yes | no] | edge [true | false] | p2p [true | false |
auto] | state [enable | disable]}
<portlist>
NOTE: As a stand-alone switch or as a master switch in a switch stack,
the switch number will be referred to as 15 for all configurations, graphs
and tables.
Used to setup STP and RSTP on the switch.
config stp {maxage <value 6-40> | hellotime <value 1-10> |
forwarddelay <value 4-30> | priority <value 0-61440> | version
[rstp | stp] | txholdcount <value 1-10> | fbpdu [enable |
disable]}
This command is used to setup the Spanning Tree Protocol (STP)
for the entire switch.
S
PANNING
63
10
T C
REE OMMANDS