D-Link DES-3350SR Reference Manual page 347

config gvrp
Parameters
Restrictions
Example usage:
To set the ingress checking status, the sending and receiving GVRP information :
local>config gvrp 1:1-1:4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Command: config gvrp 1:1-1:4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Success.
local>
enable gvrp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
DES-3350SR Layer 3 Gigabit Switch
<portlist> A range of ports for which you want ingress checking.
all Specifies all of the ports on the switch.
state [enable | disable]
specified in the port list.
ingress_checking [enable | disable]
checking for the specified port list.
acceptable_frame [tagged_only | admit_all] – This parameter
states the frame type that will be accepted by the switch for this
function. tagged_only implies that only VLAN tagged frames will be
accepted, while admit_all implies tagged and untagged frames will
be accepted by the switch.
pvid <vlanid 1-4094>– Specifies the default VLAN associated with
the port.
Only administrator-level users can issue this command.
Used to enable GVRP on the switch.
enable gvrp
This command, along with disable gvrp below, is used to enable
and disable GVRP on the switch, without changing the GVRP
configuration on the switch.
None.
Only administrator-level users can issue this command.
99
Enables or disables GVRP for the ports
Enables or disables ingress