D-Link DES-3350SR Reference Manual page 411

config time
Synta
Description
Parameters
Restrictions
Example usage:
To manually set system time and date settings:
local>config time 17012005 17:28:30
Command: config time 17jan2005 17:28:30
Success.
local>
show time
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the time currently set on the switch's System clock:
DES-3350SR Layer 3 Gigabit Switch
{time <time hh:mm:ss> | date <date ddmmyyyy> | time-zone
{operator [+ |-] | hour <gmt_hour 0-13> | min <minute 0-59>} | dst
[disable | repeating {s-which <start_which 1-4,last> | s-day
<start_day sun-sat> | s-mth <start_mth 1-12> | s-time <start_time
hh:mm> | e-which<end_which 1-4,last> | e-day <end_day sun-sat>
| e-mth<end_mth 1-12> | e-time <end_time hh:mm> | offset [30 |
60]} | annual {s-date <start_date 1-31> | s-mth <start_mth 1-12> |
s-time <start_time hh:mm> | e-date <end_date 1-31> | e-mth
<end_mth 1-12> | e-time <end_time hh:mm> | offset [30 | 60]}]}
This will configure the system time and date settings. These will be
overridden if SNTP is configured and enabled.
date – Express the date using two numerical characters for the
day of the month, three alphabetical characters for the name of the
month, and four numerical characters for the year.
time – Express the system time using the format hh:mm:ss, that is,
two numerical characters each for the hour using a 24-hour clock,
the minute and second. For example: 19:42:30.
Only administrator-level users can issue this command. Manually
configured system time and date settings are overridden if SNTP
support is enabled.
Used to display the current time settings and status.
show time
This will display system time and date configuration as well as
display current system time.
None.
Only administrator-level users can issue this command.
163