Ip Multicasting Commands - D-Link DES-3350SR Reference Manual

The IP multicasting commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
show ipmc cache
show ipmc
Each command is listed, in detail, in the following sections.
show ipmc cache
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To display the current IP multicast forwarding cache:
local>show ipmc cache
Command: show ipmc cache
Multicast
Group
------------------
224.1.1.1
224.1.1.1
224.1.2.3
Total Entries: 3
local>
DES-3350SR Layer 3 Gigabit Switch
Parameters
{group <group>} {ipaddress <network_address>}
{ipif <ipif_name 12> | protocol [dvmrp | pim]}
Used to display the current IP multicast forwarding cache.
show ipmc cache {group <group>} {ipaddress
<network_address>}
This command will display the current IP multicast forwarding
cache.
<group> The multicast group ID.
ipaddress <network_address>
the destination. You can specify the IP address and netmask
information using the traditional format or the CIDR format. For
example, 10.1.2.3/255.255.0.0 or 10.2.3.4/16.
None.
Source Address/Netmask Upstream
----------------
10.48.74.121/32
20.48.74.25 /32
10.48.75.3 /3
IP M
ULTICASTING
The IP address and netmask of
Expire
Neighbor Time
--------------- ----------
10.48.75.63 30
20.48.75.25 20
10.48.76.6 30
205
34
C
OMMANDS
Routing
Protocol
---------
dvmrp
dvmrp
dvmrp