D-Link DES-3350SR Reference Manual page 331

Command
show
bandwidth_control
config 802.1p
user_priority
show 802.1p
user_priority
config 802.1p
default_priority
show 802.1p
default_priority
show scheduling
config scheduling
Each command is listed, in detail, in the following sections.
config bandwidth_control
Purpose
Syntax
Description
Parameters
Restrictions
DES-3350SR Layer 3 Gigabit Switch
Parameters
{<portlist>}
{<priority 0-7> <class_id 0-3>}
[<portlist> | all] | <priority 0-7>
{<portlist> | all}
show scheduling
<class_id 0-3> { max_packet <value 0-255> | max_latency <value
0-255> }
Used to configure bandwidth control on a by-port basis.
<portlist>{rx_rate [ no_limit | <value 1-1000>] | tx_rate
[ no_limit | <value 1-1000>]}
The config bandwidth_control command is used to configure
bandwidth on a by-port basis.
<portlist> Specifies a port or range of ports to be configured.
all – Choose this parameter to select all configurable ports.
rx_rate Specifies that one of the parameters below (no_limit or
<value 1-1000>) will be applied to the rate at which the above
specified ports will be allowed to receive packets
§ no_limit
Specifies that there will be no limit on the rate
of packets received by the above specified ports.
§ <value 1-1000>
the above ports will be allowed to receive.
tx_rate Specifies that one of the parameters below (no_limit or
<value 1-1000>) will be applied to the rate at which the above
specified ports will be allowed to transmit packets.
§ no_limit
Specifies that there will be no limit on the rate
of packets received by the above specified ports.
§ <value 1-1000>
the above ports will be allowed to receive.
Only administrator-level users can issue this command.
83
Specifies the packet limit, in Mbps, that
Specifies the packet limit, in Mbps, that