Dell PowerConnect W-7200 Series Reference Manual page 1170

The following example shows the ntp servers configuration. The NTP server IP address, key ID and iburst status are
shown when the ntp servers brief command is used.
(host) (config) #show ntp servers brief
server 1.1.1.1
server 10.1.1.245 iburst key 12345
Related Commands
To configure an NTP server, use the command
Command History
Release
ArubaOS 3.0
ArubaOS 6.1
Command Information
Platforms
All platforms
1170 | show ntp servers
key 1234
Modification
Command introduced
The key-id parameter output displays when the ntp servers brief command is used.
Licensing
Base operating system
ntp server.
Command Mode
Enable and Config mode on local and master
controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide