Dell PowerConnect W-7200 Series Reference Manual page 1135

show log ap-debug
show log ap-debug{[<number>][all]}
Description
Show the controller's AP debug logs.
Syntax
Parameter
<number>
all
Example
This example shows the ten most recent AP debug logs for the controller.
(host) #show log ap-debug 10
Nov 24 20:54:24
All Rights Reserved
Nov 24 20:54:24
BSSID(s)
Nov 24 20:54:24
Nov 24 20:54:24
BSSID(s)
Nov 24 20:54:24
Nov 24 20:54:24
(January 9, 2006)
Nov 24 20:54:24
eth0
Nov 24 20:54:25
Command History
This command was available in ArubaOS 3.0.
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Start displaying the log output from the specified number of lines from the end of the log.
Shows all the AP debug logs for the controller.
KERNEL(AP39@10.6.1.21): Copyright (c) 2005-2006 Atheros Communications, Inc.
KERNEL(AP39@10.6.1.21): wifi0: Base BSSID 00:1a:1e:25:97:d0, 16 available
KERNEL(AP39@10.6.1.21): edev->dev_addr=00:1a:1e:ca:59:7c
KERNEL(AP39@10.6.1.21): wifi1: Base BSSID 00:1a:1e:25:97:c0, 16 available
KERNEL(AP39@10.6.1.21): edev->dev_addr=00:1a:1e:ca:59:7c
KERNEL(AP39@10.6.1.21):
KERNEL(AP39@10.6.1.21): secure_jack_link_state_change: Error finding device
KERNEL(AP39@10.6.1.21): Kernel watchdog refresh ended.
Licensing
Base operating system
^H<6>Ethernet Channel Bonding Driver: v3.0.1
Command Mode
Available in Enable and Config modes.
show log ap-debug | 1135