Active Cp Commands - HP StorageWorks MSA 2/8 - SAN Switch Reference Manual

Control Processor Commands

Active CP Commands

When you are logged into the Active CP, the full suite of commands are supported
(subject to which license keys are installed).
HP recommends that you log into a specific logical switch, when performing
management functions, rather than the Active CP. This method guarantees that
any commands you execute are run on the desired logical switch.
When you open a telnet session to the Active CP IP Address, commands execute
by default on logical switch 0. When you open a connection through the Console
or Modem port, a prompt requires you to specify which logical switch you are
connecting to.
938 Fabric OS Version 3.1.x/4.1.x Reference Guide