Fabric OS Commands
Note:
qlEnable command cannot re-enable that port, because it has been removed from
QuickLoop management. The port must be specifically re-enabled using the
qlPortEnable command.
If Advanced Zoning is in use the qlDisable, qlEnable, and qlPartner
commands are not in effect. In this case, the qlPortEnable command can be used
to enable individual ports.
This command requires an Advanced Zoning license.
Operands
None.
Example
The following entry enables QuickLoop mode:
switch:admin> qlenable
Setting switch to Quick Loop mode,
Committing configuration...done.
switch:admin>
See Also
qlDisable
qlPortEnable
qlShow
648
If the qlPortDisable command has been entered for a specific port, the
Fabric OS Version 3.1.x/4.1.x Reference Guide