HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 136

Fabric OS Commands
5. Check that all other ASICs (~Y) do not have its:
Operands
This command has the following operands:
passcnt
(V3.1.x only)
--slot number
(V4.1.x only)
-passcnt count
(V4.1.x only)
-txports list
(V4.1.x only)
-rxports list
(V4.1.x only)
-skip mask
(V4.1.x only)
136
If a good checksum test, check that:
— CMI error bit is not set.
— CMI error interrupt status bit is not set.
if a bad checksum test, check that:
— CMI error bit is set.
— CMI error interrupt status bit is set.
Capture flag set.
CMI error bit set.
CMI error interrupt status bit set.
Specify the number of times to perform this test. The
default value is 1. This operand is optional.
Specify the slot number to test. The default is set to 0 and
designed to operate on fixed port count products.
Specify the number of test passes to run. By default the test
will be run one time.
Specify a list of ports to transmit data. By default all the
ports in the specified slot (--slot number) will be
used. See itemlist help pages for further details. This
operand is optional.
Specify a list of ports to receive data. By default all the
ports in the specified slot (--slot number) will be
used. See itemlist help pages for further details.This
operand is optional.
Specify the particular test by using the following bit weight
data:
1 CMI data test (ignore checksum)
2 CMI checksum test
3 Enable all tests
This operand is optional.
Fabric OS Version 3.1.x/4.1.x Reference Guide