Configupload - HP StorageWorks MSA 2/8 - SAN Switch Reference Manual

configUpload

Create a backup file of switch configuration information on a host workstation.
Synopsis
configUpload ["host","user","file"[,"passwd"]]
Availability
Admin
Release
V3.1.x and V4.1.x
Description
Use this command to upload the switch configuration to a host file. The upload
process uses FTP or RSHD.
If the command is entered without operands, it becomes interactive and prompts
the user for input.
The configuration file is written as three sections. The first section contains the
switch boot parameters. It has variables such as the switch's name and IP address.
This section corresponds to the first few lines of output of the configShow
command.
The second section contains general switch configuration variables, such as
diagnostic settings, fabric configuration settings, and SNMP settings. This section
corresponds to the output of the configShow command (after the first few
lines), although there are more lines uploaded than shown by the command.
The third section contains the zoning configuration parameters.
Note:
not require the passwd operand.
In V4.1.x, no spaces are allowed between operands.
Fabric OS Version 3.1.x/4.1.x Reference Guide
V3.1.x supports FTP and RSHD protocol for configuration uploads. RSHD does
configUpload
147