HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 880

Fabric OS Commands
Metric:
Hops:
Flags:
Next (Dom, Port):
The information provided by this command should match what is provided by
portRouteShow and topologyShow.
Operands
This command has the following operands:
slotnumber
(V4.1.x only)
portnumber
domainnumber
If no operand is specified, this command displays routing information for all
active ports on the local switch, to all the domains in the fabric.
880
Cost of reaching the destination domain.
Maximum number of hops required to reach the
destination domain.
Indicates if route is dynamic (D) or static (S). A dynamic
route is discovered automatically by the FSPF path
selection protocol. A static route is assigned using the
command uRouteConfig.
Domain and port number of the next hop. These are the
domain number and the port number of the switch to
which Out Port is connected.
Specify the slot number for a StorageWorks Core
switch. For all other switches this operand is not
required. The slot number must be followed by a slash
( / ) and the port number, so that each port is
represented by both slot number (1 through 4, or 7
through 10), and port number (0 through 15).
The StorageWorks Core switch has a total of 1–10
slots. Slot number 5 and 6 are control processor cards,
and slot 1 through 4, and 7 through 10, are port
cards. On each port card, there are 16 ports counted
from the bottom, 0 to 15.
Specify a port number. Valid values for port number
vary depending on the switch type. This operand is
optional.
Displays routing information for the specified domain.
This operand is optional. This operand should only be
specified when the port number is specified.
Fabric OS Version 3.1.x/4.1.x Reference Guide