Diagfaillimit - HP StorageWorks MSA 2/8 - SAN Switch Reference Manual

diagfaillimit

Set diagnostics fail limit to a specified value.
Synopsis
diagfaillimit [limit | -show]
Availability
Admin
Release
V4.1.x
Description
Use this command to set the diagnostics fail limit to a specified value. The fail
limit controls the number of failures before certain diagnostics test methods will
abort. The normal setting is 1 so that the tests will abort on the first failure. The
exact use of this configuration setting depends on the test method. The new fail
limit mode becomes active as soon as this command is executed. It does not
require a reboot to take effect.
Operands
This command has the following operands:
limit
-show
If no operand is specified the current value is displayed.
Fabric OS Version 3.1.x/4.1.x Reference Guide
Specify the number of failures before a diagnostic test
aborts. The limit value must be 1 or greater. This operand
is optional.
Specify this operand to display the current fail limit setting.
This operand is optional.
diagfaillimit
189