HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 554

Fabric OS Commands
Operands
This command has the following operands:
slotnumber
(V4.1.x only)
portnumber
554
Locked L_Port is displayed as ON when port is locked to L_Port only or
blank (--) when L_Port lock mode is disabled (and it behaves as a U_Port).
This value is set by the portCfgLport command.
Locked G_Port is displayed as ON when port is locked to G_Port only or
blank (--) when G_Port lock mode is disabled (and it behaves as a U_Port).
This command is set by the portCfgGport command.
Disabled E_Port is displayed as ON when port is not allowed to be an E_Port
or blank (--) when the port is allowed to function as an E_Port. This command
is set by the portCfgEport command.
Mcast LoopBack mode (V4.1.x only) is displayed as blank (..) when Mcast
LoopBack mode is off, and (ON) when Mcast LoopBack mode is enabled.
Persistent Disable is displayed as ON when the port is disabled across reboots
or power cycles or (..) when the port is allowed to function normally. This
mode is set by the portcfgpersistentdisable command.
ISL R_RDY Mode is displayed as ON when the port has been R_RDY mode
enabled or blank (--) when the port is allowed to function as an E_Port. This
mode is set by the portcfgislmode command.
Specify the slot number for a StorageWorks Core switch.
For all other switches this operand is not required. The slot
number must be followed by a slash ( / ) and the port
number, so that each port is represented by both slot
number (1 through 4, or 7 through 10), and port number
(0 through 15).
The StorageWorks Core switch has a total of 1–10 slots.
Slot number 5 and 6 are control processor cards, and slot
1 through 4, and 7 through 10, are port cards. On each
port card, there are 16 ports counted from the bottom, 0 to
15.
Specify a port number. Valid values for port number vary
depending on the switch type. This operand is optional.
Fabric OS Version 3.1.x/4.1.x Reference Guide