HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 505

Operands
This command has the following operands:
slotnumber
(V4.1.x only)
portnumber
monitorId
Example
To delete an end-to-end monitor on blade 7 port 2:
switch:admin> perfDelEEMonitor 7/2, 5
End-to-End monitor number 5 deleted
switch:admin>
switch:admin> perfdeleemonitor 2
This will remove ALL EE monitors on port 2, continue? (yes, y, no, n): [no] y
switch:admin>
See Also
perfShowEEMonitor
perfAddEEMonitor
Fabric OS Version 3.1.x/4.1.x Reference Guide
Specify the slot number for a StorageWorks Core
switch. For all other switches this operand is not
required. The slot number must be followed by a slash
( / ) and the port number, so that each port is
represented by both slot number (1 through 4, or 7
through 10), and port number (0 through 15).
The StorageWorks Core switch has a total of 1–10
slots. Slot number 5 and 6 are control processor cards,
and slot 1 through 4, and 7 through 10, are port
cards. On each port card, there are 16 ports counted
from the bottom, 0 to 15.
Specify a port number. Valid values for port number
vary depending on the switch type. This operand is
required.
Specify the monitor number you want to delete.
Monitor numbers are defined when you create the
monitor on a port. This operand is optional. When not
specified, all monitors on the port are deleted.
perfDelEEMonitor
505