Fanenable - HP StorageWorks MSA 2/8 - SAN Switch Reference Manual

fanEnable

Enable a fan unit.
Synopsis
fanEnable unit
Availability
Admin
Release
V4.1.x
Description
Use this command to set the fan unit back to the default RPM speed only if the fan
unit has been previously disabled using the fanDisable command.
Operand
This command has the following operand:
unit
Example
To enable a fan that has been disabled:
switch:admin> fanenable 1
Fan unit 1 has been enabled
switch:admin> fanshow
Fan #1 is OK, speed is 2237 RPM
Fan #2 is OK, speed is 2500 RPM
Fan #3 is OK, speed is 2445 RPM
Fabric OS Version 3.1.x/4.1.x Reference Guide
Specify the fan's unit number. View the fan unit numbers using the
fanShow command. This operand is required.
fanEnable
257