Cfgsave - HP StorageWorks MSA 2/8 - SAN Switch Reference Manual

cfgSave

Save zone configuration to non-volatile memory.
Synopsis
cfgSave
Availability
Admin
Release
V3.1.x and V4.1.x
Description
Use this command to save the current zone configuration. The defined
configuration and the name of the enabled configuration are written to
non-volatile memory in all switches in the fabric.
The saved configuration is automatically reloaded by the switch on power up and,
if a configuration was in effect at the time it was saved, the same configuration is
reinstalled with an automatic cfgEnable command.
Because the saved configuration is reloaded at power on, only valid configurations
are saved. The cfgSave command verifies that the enabled configuration is
valid by performing the same tests as cfgEnable. If the tests fail, an error is
displayed and the configuration is not saved. Tests may fail if a configuration has
been modified since the last cfgEnable.
This command ends and commits the current transaction. If a transaction is open
on a different switch in the fabric when this command is run, the transaction on
the other switch is automatically aborted. A message is displayed on the other
switch notifying the transaction abort.
Note:
When security is enabled, this command can only be issued from the Primary FCS
switch. See
Fabric OS Version 3.1.x/4.1.x Reference Guide
This command requires an Advanced Zoning license.
"Security Commands" on page 941.
cfgSave
111