HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 74

Fabric OS Commands
Note:
switchdisable command.
Compared to bladediag, this is a limited test for single blade functionality,
which does not involve backplane connections.
Options
This command has the following operands:
[--slot] slotno
-log logfile
74
To run this command, you must disable the entire switch with the
Specify the slot number for a StorageWorks Core switch.
For all other switches this operand is not required. The slot
number must be followed by a slash ( / ) and the port
number, so that each port is represented by both slot
number (1 through 4, or 7 through 10), and port number
(0 through 15).
The StorageWorks Core switch has a total of 10 slots. Slots
number 5 and 6 are control processor cards, and slots 1
through 4, and 7 through 10, are port cards. On each
port card, there are 16 ports counted from the bottom, 0
to 15.
Specify that the output of the command will be placed in a
file named by the logfile argument. The log file will
contain all activity that occurred during the execution of
the command. All error messages are also saved in the
logfile. If this option is not specified, no log file is created.
Fabric OS Version 3.1.x/4.1.x Reference Guide