Fabric OS Commands
Operands
This command has the following operands:
port
(V3.1.x only)
-slot slot
(V4.1.x only)
-switch switch
(V4.1.x only)
-all
(V4.1.x only)
If no operand is specified, the default is to clear all bad port flags.
Example
To clear the diag software flag:
switch:admin> > diagclearerror 1
0x1bcb (fabos):
Pt5 Sl1 Ch0 Qd1 Diagnostics Error Cleared
Err# 0120041 0105
See Also
diagShow
180
Specify the port where you want to clear diagnostic error
messages. This operand is optional.
Specify the slot to clear the diagnostic failure status. This
operand is optional.
Specify the logical switch number to operate on. If
omitted, then all blades will be cleared. This operand is
optional.
If specified, all blades will be cleared.
Switch: 0, Error DIAG-CLEARERR, 3,
Fabric OS Version 3.1.x/4.1.x Reference Guide