Configure Command System Services Parameters - HP StorageWorks MSA 2/8 - SAN Switch Reference Manual

Always send RSCN?
Do Not Allow AL_PA
0x00?
Initialize All Looplets?
(V3.1.x only)
System Services
The System Services fields are as follows:
Table 5: Configure Command System Services Parameters
rstatd
rusersd
telnetd (V4.1.x only)
rapid
thad
Disable RLS probing
Descriptions of the system service setting fields are as follows:
rstatd
Fabric OS Version 3.1.x/4.1.x Reference Guide
Following the completion of loop initialization, a
remote state change notification (RSCN) is issued
when FL_Ports detect the presence of new devices or
the absence of pre-existing devices. When set, a
RSCN is issued upon completion of loop initialization,
regardless of the presence or absence of new or
preexisting devices.
This option disallows AL_PA values from being 0.
When this is set, all looplets including the ones not in
the same zone are always re-initialized. This is
required for certain RAID subsystems to work properly
during failover.
Field
Dynamically enables or disables a server that returns
information about system operation information through
remote procedure calls (RPC). The protocol provides for
a wide-range of system statistics.
The retrieval of this information is supported by a
number of operating systems which support RPC. Most
UNIX-based systems (HP-UX, Irix, Linux, Solaris, etc.)
use the rup and rsysinfo commands to retrieve the
information. See your local system documentation for
the appropriate usage of the these or equivalent
commands.
Default Range
Off On/Off
Off On/Off
On On/Off
On On/Off
On On/Off
On On/Off
configure
157