HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 758

Fabric OS Commands
For Finisar "smart" SFPs, five additional fields are displayed:
Operands
This command has the following operands:
slotnumber
(V4.1.x only)
portnumber
Example
The example below shows SFP summary information:
switch:admin> sfpshow
port 0: id (sw) Vendor: AGILENT
port 1: id (sw) Vendor: AGILENT
port 2: id (sw) Vendor: AGILENT
port 3: id (sw) Vendor: AGILENT
port 4: id (sw) Vendor: AGILENT
port 5: id (sw) Vendor: AGILENT
port 6: id (sw) Vendor: AGILENT
port 7: id (sw) Vendor: AGILENT
switch:admin>
758
Module temperature
Voltage
Received optical power
Transmitted optical power (longwave only)
Laser diode drive current
Specify the slot number for a StorageWorks Core switch. For
all other switches this operand is not required. The slot number
must be followed by a slash ( / ) and the port number, so that
each port is represented by both slot number (1 through 4, or
7 through 10), and port number (0 through 15).
The StorageWorks Core switch has a total of 1–10 slots. Slot
number 5 and 6 are control processor cards, and slot 1
through 4, and 7 through 10, are port cards. On each port
card, there are 16 ports counted from the bottom, 0 to 15.
Specify a port number. Valid values for port number vary
depending on the switch type. This operand is optional.
Serial No: A00128928
Serial No: A00128983
Serial No: A00128966
Serial No: A00128929
Serial No: A00128988
Serial No: A00127279
Serial No: A00127399
Serial No: A00127264
Fabric OS Version 3.1.x/4.1.x Reference Guide