Qloopshow - HP StorageWorks MSA 2/8 - SAN Switch Reference Manual

qloopShow

Displays QuickLoop information.
Synopsis
qloopShow [pattern][, mode]
Availability
All users.
Release
V3.1.x and V4.1.x
Description
Use this command to display QuickLoop configuration information.
If no parameters are specified, all zone configuration information (defined and
enabled) is displayed. See cfgShow for a description of this display.
If a parameter is specified, it is used as a pattern to match QuickLoop names;
those that match in the defined configuration are displayed.
This command changes the Defined Configuration. For the change to be preserved
across switch reboots, it must be saved to non-volatile memory using the
cfgSave command. For the change to become effective, an appropriate zone
configuration must be enabled using the cfgEnable command.
Note:
When security is enabled, this command can only be issued from the Primary FCS
switch. See
Fabric OS Version 3.1.x/4.1.x Reference Guide
This command requires an Advanced Zoning license.
"Security Commands" on page 941.
qloopShow
657