AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 510

PRI Facilities
Network Service
Use this procedure to specify the type of outgoing service provided by each
B-channel group [Megacom WATS and 800, MultiQuest
Switched Digital Service (SDS), or Software Defined Network (SDN)].
NOTE:
You can enter a service not shown on the Network Service screen by using the
five-digit binary code that represents the service in the Network Facilities
Information Element of ISDN PRI signaling protocol. For information on these
codes, contact your service provider. See "Miscellaneous Procedure."
Summary: Network Service
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Procedure: Network Service
Console Display/Instructions
1 Select the Lines and Trunks menu.
_
4–138
Programming Procedures
System manager
Hybrid/PBX, Key
Not required
Form 3b, Incoming Trunks: DS1 Connectivity
(100D module)
Not applicable
AT&T Toll, Local, Miscellaneous
No
No
group no. Specify network service
network service
Additional Information
â
Service, ACCUNET
Type group no.
â
Dial
Specify
PC