AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 474

Tie Trunks
Console Display/Instructions
4 Enter a tie trunk number.
5 Save your entry.
Select .
6 Specify the type of signaling for the trunk.
NNN
_
_
_
7 Continue to assign E&M signaling to another trunk or go to Step 8.
Select .
8 Save your entry.
Select .
9 Return to the System Programming menu.
Select two times.
Dial Mode
Use this procedure to specify whether an incoming or outgoing tie trunk is touch-
tone or rotary.
Touch-tone cannot be programmed for incoming immediate signaling tie trunks.
Users of touch-tone single-line telephone users cannot make calls by using
individual trunks programmed for rotary operation. The touch-tone signals
generated from the telephone while dialing are transmitted to the central office at
the same time the rotary signals are sent to the system. The central office
receives both signals and cannot process the call.
4–102
Programming Procedures
Additional Information
Dial or type:
Trunk number [ nnn ]
*
Slot and port number

Logical ID number [ nnn ].
xxx = trunk entered in Step 4
Select ,
, or
.
Return to Step 6. The next trunk will be
displayed on Line 1.
PC
[ sspp ]