AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 487

DID Trunks
Console Display/Instructions
4 Enter the trunk block ( n = 1 or 2).
5 Save your entry.
Enter Enter
Select .
6 Specify the line(s).
_
_
_
_
Single Line Procedure
1 Specify entry mode.
Entry Mode Entry Mode
Select
2 Enter the trunk number.
3 Assign or remove the trunk.
Enter
Enter
Select or
Delete Delete
.
4 Continue to enter trunks for the other trunk block or go to Step 5.
Next Next
Select .
Dial or type [ n ].
For a single line, go to
Single Line Procedure.
_
For a block of lines, go to
Block Procedure.
.
x = block entered in Step 4
Dial or type [ nnn ].
You may continue to assign or remove
DID trunks from the block by repeating
Steps 2 and 3.
Return to Step 2. The block will be
displayed on Line 1.
Additional Information
Programming Procedures
PC
4–115